IFTAComplianceA resource from TIN Comply
Calculator

Weight-distance tax checker by route

Kentucky, New Mexico, New York, Oregon and Connecticut each charge heavy trucks by the mile, apart from IFTA, and each starts at a different weight. Pick the states on your route and the truck's weight to see which apply, the trigger, the rate basis, how to register and the option for occasional trips. Add miles for a rough estimate in Kentucky, New York and Oregon.

Updated November 21, 2026Sources KRS 138.655 and 138.660; Section 7-15A-6 NMSA 1978; NY Form MT-903-I and TB-HU-115; ODOT Forms 9928-2024 and 9928-2027; 2021 Conn. Pub. Acts 177Privacy runs in your browser; nothing you enter is sent or stored

States on the route

The heaviest weight it runs at: gross with the load, or the declared or registered weight. Each state’s test is below.
Two or more units. Connecticut covers multi-unit trucks only.
ODOT Form 9928-2024 or 9928-2027. Oregon moves to registered weight on July 1, 2027.

Miles in the period (optional, for a rough estimate)

Flat $0.0285 a mile.
MT-903-I, Table 1 rate.
Form 9928 Table A rate.

Example values: an 80,000 lb tractor-trailer with 1,000 Kentucky, 1,500 New York and 3,000 Oregon miles. Replace them with your own. New Mexico and Connecticut rates are on their guides.

How the checker decides

Five states charge heavy trucks by the mile, on top of the fuel tax you report on IFTA. Each one has its own weight test, and none of them is the IFTA test of over 26,000 pounds or three axles. The checker applies each state’s own test to the weight you enter:

StateTest the checker appliesSource
Kentucky (KYU)Over 59,999 lb“KYU is a tax license issued for all carriers traveling on Kentucky roadways with a combined license weight greater than 59,999 pounds.”
New Mexico (WDT)Over 26,000 lbNM Taxation and Revenue Department: carriers with “a declared gross weight or gross vehicle weight over 26,000 pounds”
New York (HUT)Over 18,000 lb“A HUT certificate of registration and decal is required for any truck, tractor, or other self-propelled vehicle with a gross weight (either alone or in combination) of more than 18,000 pounds.”
Oregon (weight-mile)Over 26,000 lb“Vehicles operating over 26,000 pounds are subject to weight-mile tax when operating in Oregon”
Connecticut (HUF)26,000 lb or more, and pulling a trailerDRS: a vehicle with “a gross weight of twenty-six thousand pounds or more and carries a classification between Class 8 and Class 13, inclusive”

The weight is not measured the same way everywhere. Kentucky uses the greater of the declared combined weight or the highest actual combined weight you ran in Kentucky during the registration period (KRS 138.655(2)), so registering lower does not keep a truck out if it runs heavier. New Mexico uses declared gross weight. New York uses gross weight, meaning the unloaded weight of the power unit and the heaviest trailer plus the maximum load, unless you elect the unloaded weight method. Oregon uses the declared weight now and the weight on the cab card from July 1, 2027: ODOT’s FAQ says “If registered weight is less than 26,001 pounds, you will no longer be subject to WMT.”

Connecticut adds a vehicle class test. FHWA Class 8 is the first class it covers, and the DRS page describes it this way: “This category includes all vehicles consisting of two units, one of which is a tractor or straight truck power unit.” A truck working alone is a single-unit vehicle in Classes 5 to 7, outside the fee, which is why the checker asks whether the truck pulls a trailer. More on each test in weight-distance taxes compared.

Where the estimate comes from

The estimate is miles times one published rate per mile, rounded to the cent, and only for the three states whose rate the checker can pick from your weight alone:

  1. Kentucky: one rate for every vehicle over the line. KRS 138.660(3) sets the tax “computed at the rate of two and eighty-five hundredths cents ($0.0285) per mile” (KRS 138.660).
  2. New York: the laden rate for your gross weight from Schedule 1, Table 1 of the MT-903 instructions (1/22), from $0.0084 a mile at 18,001 to 20,000 lb to $0.0546 at 78,001 to 80,000 lb. It assumes every mile is laden and off the Thruway (the full return is on MT-903 line by line); the form says “Exclude miles traveled on the toll-paid portion of the Thruway.” Unladen miles have lower rates in Tables 2 and 3.
  3. Oregon: Table A of Form 9928-2024 by declared weight, or the registered weight table on Form 9928-2027 for miles from July 1, 2027. Empty miles count the same: “If returning empty, use the same declared weight and rate as when loaded.” Above 80,000 lb under the 2024 table, the rate depends on axles (Table B), so the checker shows no estimate.

New Mexico and Connecticut also charge by weight and mile. Their rate tables are on the New Mexico and Connecticut guides; New Mexico’s rates rose about 35 percent on July 1, 2026 (Laws 2026, ch. 4).

Worked examples

Truck and routeWhat the checker shows
Tractor-trailer at 80,000 lb through Kentucky, New York and Oregon; 1,000, 1,500 and 3,000 miles (the example values)All three apply. KYU $28.50 (1,000 × $0.0285); HUT $81.90 (1,500 × $0.0546); Oregon $753.60 (3,000 × $0.2512). Rough total $864.00.
Straight truck alone at 33,000 lb, all five statesNew Mexico, New York and Oregon apply. Kentucky does not (not over 59,999 lb) and Connecticut does not (single unit). New York laden rate $0.0154; Oregon 88.4 mills ($0.0884).
Tractor-trailer registered at exactly 26,000 lb, all five statesNew York and Connecticut apply (over 18,000 lb; 26,000 lb or more). New Mexico and Oregon do not (not over 26,000 lb), and neither does Kentucky.
Tractor-trailer at 62,000 lb, Oregon only, 1,000 miles2024 table: 151.7 mills, $151.70. Switch to the 2027 table: 143.1 mills, $143.10.

Limits

The checker applies the weight tests and does the arithmetic on your numbers. It does not apply exemptions (farm plates in Kentucky, excluded vehicles in New York, milk haulers in Connecticut), New York’s unloaded weight method, New Mexico’s one-way haul rate or Oregon’s flat fee options, and the estimate is not your return. Rates as of November 2026. General information, not tax advice; each state’s own law and instructions control.

Each state wants its own account before the first trip, or its temporary credential, and a return for every period once you hold the account, even with no miles there. IFTA does not cover any of them: the Articles say IFTA’s procedures “apply to motor fuel use taxes that are imposed by each jurisdiction on the consumption of motor fuel or other fuels” (IFTA Articles of Agreement R800). Put the state due dates next to your IFTA dates with the deadline calendar, and check the federal filings with which filings do I need.

Questions filers ask

Does my IFTA license cover Kentucky, New York or Oregon mileage taxes?

No. IFTA covers motor fuel use taxes only (R800). Each weight-distance tax has its own account and return with that state. Kentucky’s IFTA manual tells its own carriers to contact New York, New Mexico, Connecticut and Oregon for a mileage tax license.

My truck is 24,000 lb. Do any of these apply?

New York’s HUT can: its line is over 18,000 pounds gross weight. The other four start at 26,000 pounds (Connecticut, with a trailer) or above.

Why does Kentucky not apply to my 55,000 lb truck?

KYU starts over 59,999 pounds combined licensed weight. A truck that never runs above 59,999 pounds in Kentucky and is not registered above it owes no KYU.

Why is the Oregon estimate so much higher than the others?

Oregon’s weight-mile tax stands in for its fuel tax on heavy trucks: enrolled carriers buy diesel in Oregon without paying Oregon fuel tax. The other four charge their mileage tax on top of fuel tax.

I go to New York or Oregon once a year. What do I need?

New York sells a $25 HUT trip certificate (10 a year at most), and Oregon a weight-mile temporary pass at $9 plus the tax for the miles. Neither covers fuel tax; without an IFTA license you also need fuel trip permits.

Does it save what I type?

No. The checker runs in your browser and sends nothing.